Config for Policy

The Expert Mode Config for Policy Screen is used to configure basic Policy parameters. When you have completed all of the parameters, click the Next button at the bottom of the screen or click on Device Selection on the left side of the screen to move to the next step.

• Name - The Policy name.
• Precedence -The Policy precedence. By default, the precedence field is pre-filled with the lowest unused precedence value. A higher number indicates higher precedence. (Range = 0 - 65535)

Click on Show Advanced Options to display and configure the options below. By default, these options are set to Ignore.

• Default List - Adds the rule to the QoS Default Policy List.
• Enable - Enables the policy.  
• Save - Marks the policy rule so that it may be captured as part of the switch configuration.
• Log Matches - Configures the switch to log messages about specific flows coming into the switch that match this policy rule.
• Send Trap - Enables traps for the Policy.
• Reflexive - Enables support for the Reflexive for the policy. Reflexive policies allow specific return connections that would normally be denied.